diff --git a/README.md b/README.md
index 1cc54ae3b..78db8522d 100644
--- a/README.md
+++ b/README.md
@@ -632,7 +632,20 @@ The IP configuration supports the following options:
   source IP address for a route. `table` supports both the numeric table and named
   table. In order to specify the named table, the users have to ensure the named table
   is properly defined in `/etc/iproute2/rt_tables` or
-  `/etc/iproute2/rt_tables.d/*.conf`. The optional `type` key supports the values
+  `/etc/iproute2/rt_tables.d/*.conf` .The network role does not create these routing table entries automatically.
+  You can use the `ansible.builtin.lineinfile` module in your playbook to
+  define the named tables before applying the network role:
+  ```yaml
+  - name: Ensure custom routing tables are defined
+  ansible.builtin.copy:
+    dest: /etc/iproute2/rt_tables.d/{{ item.name }}.conf
+    content: "{{ item.table_id }}\t{{ item.name }}\n"
+  loop:
+    - { table_id: 100, name: mytable1 }
+    - { table_id: 101, name: mytable2 }
+  become: true
+  ```
+  The optional `type` key supports the values
   `blackhole`, `prohibit`, and `unreachable`.
   See [man 8 ip-route](https://man7.org/linux/man-pages/man8/ip-route.8.html#DESCRIPTION)
   for their definition. Routes with these types do not support a gateway. If the type
@@ -684,7 +697,20 @@ The IP configuration supports the following options:
       The route table to look up for the `to-table` action. `table` supports both the
       numeric table and named table. In order to specify the named table, the users
       have to ensure the named table is properly defined in `/etc/iproute2/rt_tables`
-      or `/etc/iproute2/rt_tables.d/*.conf`.
+      or `/etc/iproute2/rt_tables.d/*.conf` .
+      The network role does not create these routing table entries automatically.
+      You can use the `ansible.builtin.lineinfile` module in your playbook to
+      define the named tables before applying the network role:
+      ```yaml
+      -  name: Ensure custom routing tables are defined
+      ansible.builtin.copy:
+        dest: /etc/iproute2/rt_tables.d/{{ item.name }}.conf
+        content: "{{ item.table_id }}\t{{ item.name }}\n"
+      loop:
+        - { table_id: 100, name: mytable1 }
+        - { table_id: 101, name: mytable2 }
+      become: true
+      ```
   - `to` -
       The destination address of the packet to match (e.g. `192.168.100.58/24`).
   - `tos` -
@@ -1504,6 +1530,12 @@ In general, to successfully run the play, determine which configuration is
 active in the first place, and then carefully configure a sequence of steps to change to
 the new configuration. The actual solution depends strongly on your environment.
 
+Routing rules and named routing tables are not supported when using the
+`initscripts` provider. If `network_provider: initscripts` is set, any
+`routing_rule` entries and named `table` references in `route` will be
+silently ignored. Use `network_provider: nm` (NetworkManager) for routing
+rule support.
+
 ### Handling potential problems
 
 When something goes wrong while configuring networking remotely, you might need