Sensor (current) INA219 not working after Firmware-update to 1.13.0

[birgerschacht]

Hello,
i have updated the firmware on a HELTEC V4 repeater from 1.11.0 to 1.13.0
and after that the i2C sensor was not displayed any more at channel 2.
(SDA wired to GPIO 17
SCL wired to GPIO 18)

here is the Datasheed of the INA219: https://www.ti.com/lit/ds/symlink/ina219.pdf?ts=1771928096177&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FINA219

chapter 8.5.5.1 for Serial Bus Addresses.

The other connected Sensor AHT20 (temerature, humidity) is still working.

Please check, thank you in advance.
Greetings, Birger

[birgerschacht]

Default Address of the INA219 is 0x40 (A0 and A1 pads unsoldered on the typical PCB)

[IoTThinks]

I2C sensors are broken when OLED off.

I have put a PR.

#1569